Handling as per SUPER Diablo but with Stronger Steering and EVEN more Stability.

The 'Drivers Choice' across Europe and the UK.

SSL Compatible
- Compatible with CODE10 (M12S (RS), Exzes ZZ, MT-44)
Not compatible with CODE5 (M12, Exzes Z, MT-4S, MT-4, MT-S)
- MULTI SETTING GEAR compatible
Not compatible with PGS SETTING GEAR
- SSR mode compatible
- SHR mode compatible
- Lipo 2 cell battery compatible
- High torque type
- Coreless motor
- Metal Gears
- AL Heat Sink

Programmable Servo to be compatible with SSL & Telemetry
- Setting Adjustment by wireless from Radio
- Setting Adjustment to connect Servo with Multi Setting Gear
- Regarding Temperature, Current, Voltage and Volume Position on Servo inside,
Telemetry-transmission can be passed to Radio.
# Initial Setting on Multi Setting Gear is necessary.

- Setting Items
- SSL-CH (SSL Channel Setting) - STRETC (Stretcher Adjustment) - BOOST (BOOST Adjustment)
- D-Band (Dead Band Adjustment) - MV-MID (Middle Torque Adjustment)
- MV-END (Later Torque Adjustment) - BREAK (Break Adjustment)
?MV-HOLD (Power Adjustment at whole area) ?MV-FRQ (Feeling Adjustment at whole area)
?MAX-PW (MAX Duty Adjustment)
- Multi Setting Gear is necessary for setting.

Speed
0.11 sec / 60° (7.4 V)
0.13 sec / 60° (6.0 V)

Torque
26.5 kg ·cm (7.4 V)
23.3 kg ·cm (6.0 V)

Dimensions
40.5 X 20.5 X 37.2 mm

Weight
59 g

NEW SPECIAL LOW PRICE.

Compatible Response Mode with SUR, SSR, SHR, NOR SSL CODE5/CODE10

Function Quick Setup Wizard Fully Adjustable Trigger Adjustable Steering and Throttle Tension INDICATOR FUNCTION can show Receiver Signal Strength and Packet Delivery Ratio Weight: 382 g

Power source: AAA Battery x 3 ONLY Compatible RF with FH5 Includes new RX-493i receiver

One of the outstanding features of MT-5 is the indicator function which can check signal receiving conditions using RX-493i. The conditions can be used for checking the device and correct receiver placement.

B0514 (MUGEN)

CLUTCH SPRING ADJUSTING TOOL FOR 1/8 & 1/10 ON ROAD.

FRONT BELT MRX6 +R/X & 7 'RUBBER'

SKYRC introduces the POWER SWITCH, a tiny MCU controlled on/off switch for your radio controlled model.

A simple push button operates the switch meaning to eliminate the problems associated with intermittent contact of an ordinary mechanical switch.
The sealed unit is plastic and can easily be mounted to the transponder mount of your model or anywhere else you can mount it using double sided tape.
(Two kinds of bottom covers are included, user can change the bottom cover.)

The switch also features a LiPo mode, by turning this on, the switch unit will auto detect low LiPo voltage and cut off power to protect your LiPo from over dis-charging. This of course can be turned off if you have other safeguards in place or using NiMH/NiCad battery.
Additionally, the power switch informs you about the remaining capacity and conditions of your battery pack.

LOW FRICTION PULLEY SET: MRX6 & 6R/X